LG LDPH7972S

Machine Clean cycle time

The manufacturer does not publish a reliable fixed duration for this exact cycle. The displayed estimate can change with sensing and selected options.

Manual-sourced timeVariableThe cycle ends according to load conditions, sensor readings, temperature and selected options.

What is the Machine Clean cycle used for?

This maintenance program cleans the empty dishwasher rather than a load of dishes.

It circulates hot water through the tub and wash system to help remove grease, mineral film and odor-causing residue. Follow the manual regarding dishwasher cleaner and run it empty.

Good match: Periodic maintenance when the tub has buildup or odor.
Choose another cycle for: Running with dishes, detergent combinations or cleaners not approved by the manufacturer.

What this means for your load

The official model documentation identifies this cycle but does not provide a dependable single duration.

Published water use: 3.2 gal. This figure applies to the documented test conditions and may be a range when the appliance senses the load.

Why the time may change: Use the specified options and cleaner; changing them can alter the time or cleaning result.

Check the full LG LDPH7972S cycle table to compare other programs before starting.

When will it finish?

Use the appliance display for the current estimate. Load conditions, sensing, temperature and selected options can move the finish time.

Estimated energy and local cost

This range is calculated from the documented cycle characteristics and appliance type. It is deliberately shown as a range because load conditions, temperature selections, sensors and options change consumption.

Estimated energy0.53–0.97 kWhModerate confidence · not a meter reading
Using the August 2026 U.S. residential average. Enter a ZIP for the state average or replace the rate with your bill rate.

Calculated from published cycle water use, an assumed 45–75°F water-temperature rise, and a machine/heating allowance. Cost excludes fixed monthly utility charges. ZIP lookup identifies a state using Zippopotam.us; this site does not save the ZIP. See calculation methodology and limitations.

Planning the Machine Clean cycle on the LDPH7972S

Machine Clean is a model-specific dishwasher program, so its controls and options should be checked against the exact appliance documentation.

On the LG LDPH7972S, watch for incoming water temperature, soil sensing, heat holds and drying options. Run hot water at the sink first when the manual recommends it, and avoid blocking spray paths.

The planning range on this page is 0.53–0.97 kWh; use the ZIP or bill-rate calculator for a local cost estimate. The exact-model reference is linked from lg.com, while estimates are labeled separately.

Compare every documented LDPH7972S cycle · Browse cycle topics

How this page was sourced

The timing and model-specific note above come from or summarize the linked LG LDPH7972S owner manual, Cycle/Option Guide, via LG support. The usage explanation adds practical context based on the cycle name and appliance type; it does not replace the model manual or an item's care label.

Primary source

LG LDPH7972S owner manual, Cycle/Option Guide, via LG support ↗

Checked October 29, 2026. Values are transcribed or summarized from the linked source. Your appliance display and current manual take priority.